Skip to content

User Manual

Fast Guard Alarms User Manual

NOTE: For Catalytic Converter Alarm Installation Instructions GO HERE

ALARM FEATURES:

  • 113dB alarm sound (louder than a car horn)
  • 7 levels of vibration sensitivity
  • Program multiple alarms to one remote
  • SOS and scare function
  • Vehicle search function
  • Low battery indicator

HOW TO USE:

ACTIVATE BATTERIES 

First, activate the batteries by pulling out the plastic tab protruding from the bottom of the alarm.

How to Arm Alarm

On the remote control press once on the button with a LOCK symbol on it. A few seconds later, you will hear one beep. This means your alarm is armed. If the alarm feels any movement it will issue two quick warning beeps (this is in case of accidental movement). If the alarm is moved again within a few seconds of the warning beeps, it will sound off for 30 seconds. After 30 seconds it goes back into regular arm mode.

How to Disarm Alarm:

Press the OPEN LOCK symbol once on the remote control. 

How to Change Ringtone Type:

There are three different types of ringtones to choose from. While the alarm is disarmed, simply press the lightning bolt button on the remote control and select your preferred ringtone.

How To Change Alarm Touch Sensitivity Level

Our alarm comes with 7 sensitivity levels from high to low. This is to account for situations where it's windy outside or there may be other movements that could accidentally set off your alarm. Note: The factory setting of your alarm is set to the highest sensitivity level.
WATCH VIDEO

Step 1

WATCH VIDEO

Press and hold the the OPEN LOCK button to the remote control until the LED light shuts off. Keep pressing until you see the LED light come back on.

Step 2

Press the circular LOCK button on the remote control as many times as you need until you have reached the desired sensitivity level. You will hear 7 tones/levels: "Do Re Mi Fa So La Ti."  "Do" is most sensative all the way down to "Ti" being the least sensative.

How To Synch A New Remote With An Existing Alarm

If you lose your remote or the battery runs out, here's how you synch a new remote:
[DEMONSTRATION VIDEO HERE]

Step 1

Open the alarm using the screwdriver and pry tool. Note: You may find it easier to use a pocket knife or flathead screwdriver instead if the pry tool. Remove one of three batteries. Wait 5 seconds, and then put it back in. Close the alarm case and put the screw back in.

Step 2

Press and hold the BELL button for several seconds until you hear one subtle beep coming from the target alarm. 

Step 3

Immediately press the ARM button once. You should hear a ringtone, which means your new remote control is active with your alarm. 

Step 4

Make sure to turn your alarm off if you don't need it in arm mode. 

How To Synch Multiple Alarms With One Remote OR MULTILE REMOTEs WITH ONE ALARM:

You can sync up to eight alarms with one remote or up to eight remotes with one alarm. This is great if you need multiple alarms but don't want to carry around a pile of remotes, or for multiple people need to control one alarm, such as multiple family members who drive one car. 

Step 1

Open up the alarm using the screwdriver and pry tool. Remove one of three batteries. Wait 30 seconds, and then put it back in. Close the alarm case and put the screw back in.

Step 2

Press and hold the BELL symbol on the remote you want to program to. You will hear one beep after several seconds. The beep is not very loud. 

Step 3

Immediatley press the ARM button once. You should hear a ringtone, which means the remote control is now synched with the destination alarm. 

Step 4

Make sure to turn your alarm off if you don't need it in arm mode.

NOTE: 
If you are adding additional alarms to a remote control or additional remote controls to an alarm, you must always start with step 1.